1. Assembling the Sliding Doors
Step #10
List of Components
| Item | | Spec | Qty |
|---|
| | Rectangular Nut | M3 | 8 |
| | ISO7380 Screw | M3x8 | 8 |
| | DIN9021 Washer | M5 | 8 |
| | Reed Switch Actuator | - | 2 |
| | Reed Switch Sensor | - | 2 |
Instructions
- Flip the two doors.
- Slide the M3 nuts in the profile as shown.
- Position the washers and the reed switches. Pay attention to positioning the wired sensor on the correct door, with its wires orientated up.
- Fix them with the M3 screws, at the bottom of the profile. Be sure that the actuator and the sensor are in front of each other.
- Repeat those operations on the two other doors.
