1. FAB

Step #01 - L structure 1/2

List of Components

ItemSpecQty 
 Galva tube1200mm1
 Galva Tube500mm1
 90° connectorØ27mm1
 45° connectorØ27mm2
 HookØ27mm1

Tools needed

Allen Key 5mm

Instructions

  1. Slide the 45° connector on the horizontal tube. Don't tighten it yet.
    1. Slide the hook at the end of the horizontal tube and tighten down.
      1. Slide the 90° connector at the other end of the horizontal tube and tighten down.
        1. Slide the small tube into the 45° connector and tighten down.
          1. Slide the second 45° connector on the other end of the small tube and tighten it.
            1. Make sure the 90° and the 45°connector are aligned before thightening the 45° connector.

              Animation

              Realising this step on a flat surface makes it much easier to achieve the correct alignment.