1. FAB

Step #02 - L structure 2/2

List of Components

ItemSpecQty 
 Galva Pipe1200mm1
 Galva HookØ27mm1
 Pivot (female)Ø27mm2

Tools needed

Allen Key 5mm

Instructions

  1. Slide the two female pivots on the tube as shown.
    1. Position the first pivot flush and the second one 440mm higher but don't tighten yet.
      1. Slide in the hook and place it 30mm higher than the female pivot.
        1. Make sure all the pivots are properly aligned then tighten.

          Animation
          It's easier to align the 90° and 45° by doing this on a flat surface.