5. Y-axis Ballscrews Assembly

Step #06 - Installing the Ballscrews (2/2)

List of Components

ItemSpecQty 
 LocknutM48
 DIN912 ScrewM4x458
 SpacerM5x198
 Bearing Support Offset-2

Tools needed

Allen Key 3mm Spanner 7mm

Instructions

  1. Position the bearing offset plate before installing the spacers. If the offset plate is difficult to install with the spacers, check the length of the ballscrews. If it is 740 (S) - 1140 (M/L) mm instead of 735(S) - 1135(M/L)mm, replace the offset plate with 4 washers of size M4.
    1. Place one spacer and secure its position with a screw.
      1. Pre-tighten the screw with a locknut.
        1. Install the three screws left using the same technique.
          1. Repeat these operations on the other mirror assembly.

            Animation

            Do not fully tighten the locknuts now.