5. Y-axis Ballscrews Assembly

Step #05 - Installing the Ballscrews (1/2)

List of Components

ItemSpecQty 
 LocknutM48
 DIN912 ScrewM4x558
 DIN9021 WasherM48
 SpacerM5x308

Tools needed

Allen Key 3mm Spanner 7mm

Instructions

  1. Install the prepared ballscrew as shown.
    1. Place one spacer and one washer between the Y-axis foot and the bearing block.
      1. Place a screw into the spacer, the screw head must be on the bearing block side.
        1. Tighten it with a locknut.
          1. Install the three screws left using the same technique.
            1. Repeat these operations on the other mirror assembly.

              Animation

              Do not fully tighten the locknuts now.