1. Table Frame
Step #05 - Preparing the Large Crosswise Profiles (2/2)
List of Components
| Item | | Spec | Qty |
|---|
| | Alu profile 6060 | 1410mm | 2 |
| | Angle bracket 6060 | - | 4 |
| | Angle bracket 3030 | - | 8 |
| | DIN912 screw | M6x16 | 16 |
| | Sliding nut | M6 | 16 |
| | DIN9021 washer | M6 | 16 |
Instructions
- Place 2 sliding nuts on each side of the aluminium profile.
- Attach a 6060 angle bracket at each end, using 2 screws and 2 washers each time. Do not fully tighten the screws.
- Turn it over and repeat these operations on the other face, using the 3030 angle brackets this time.
- Replicate the same assembly a second time.
Animation
