3. Installing the Doors

Step #09

List of Components

ItemSpecQty
SML
 Cable Chain End ConnectorMale222
 Cable Chain End ConnectorFemale222
 Cable Chain 400mm22-
 Cable Chain 600mm22-
 LocknutM4222
 ISO7380 ScrewM4x8444

Tools needed

Allen Key 2.5mm Spanner 7mm

Instructions

  1. Attach the male connector to the front-bottom profile of the structure, using the M4 square nut that you placed earlier. It should be placed close to the foot of the machine, as shown in the first picture.
    1. Attach the female connector to the angle bracket located on the left door.
      1. Take the cable chains and open all the bridges.
        1. Place the sensor cable inside the chain and close the bridges.
          1. Connect the chain to both end connectors.
            1. Try opening and closing the door to see if it moves correctly. The last picture below shows how it should look like when the door is open.
              1. Repeat those operations at the back door of the enclosure

                Make sure you attached the cable chain at the front doors and at the back doors of the enclosure.