3. Installing the Doors

Step #03

List of Components

ItemSpecQty (S/M/L)
 Emergency Stop Button-1
 Sliding NutM42
 DIN912 ScrewM4x122

Tools needed

Allen Key 3mm Phillips screwdriver

Instructions

  1. Take the emergency stop button that you removed earlier and open it by removing the four cross-head screws.
    1. Insert two sliding nuts in one of the table's profile, preferably on the right side next to the interface unit.
      1. Use the M4x12 screws to attach the button to the table
        1. Close the button using the four cross-head screws.

          Make sure the cables of the Emergency stop button and the Interface Unit are properly passing by the cable holder.