Dust Collection Kit

Step #7 - Attaching the Hose to the Dust Collector (1/2)

List of Components

ItemSpecQty
 Wago2-pole1
 Hose clamp10cm1
 Grounding cable70cm1
 Hose10m1

Tools needed

Cutter /
Scissors 		Screwdriver

Instructions

  1. Using the box cutter, trim approximately 2cm of the copper wire.
    1. Open one pole of the Wago connector, insert the copper wire and then close it.
      1. Repeat the same operation with the grounding cable on the second pole of the Wago connector.
        1. Pre-place the clamping collar over the hose.
          Make sure the copper and the grounding cable are firmly inserted in the Wago connector
          Be careful not to cut yourself while removing the plastic around the copper wire. If you own a pair of wire strippers, even better to use them.