1. FAB

Step #06 - Assembling the Structure

List of Components

ItemSpecQty 
  Sliding NutM64
 WasherDIN 9024
 Tooth lock washerDIN 9854
 ScrewM6x202
 ScrewM6x162

Tools needed

Allen Key 5mm

Instructions

  1. Insert the 2 sliding nuts in the railing (as shown below).
    1. Insert the 2 sliding nuts in the back side of the railing (as shown below).
      1. Add the connection plate and align it with the sliding nuts in the railing.
        1. Place the washer and the tooth lock washer.
          1. Secure it with the M6x20 screw.
            1. Repeat both steps for the second screw.
              1. On the back side, place the washer & the tooth lock washer -- tighten down the M6x16 screw.
                1. Repeat this step.
                  1. Slide the lower tube into the 2 round brackets. Let the pipe extend 100mm past the bottom bracket. Tighten down hard.
                    1. Slide the upper tube onto the lower tube.

                      Animation

                      Make sure that the connection plate is screwed down tight.