1. FAB

Step #05 - Connection Plate

List of Components

ItemSpecQty 
 Connection Plate/1
 Round Mounting BracketØ27mm2
 Angle Bracket30*302
 Lock NutM102
 Lock NutM62
 WasherDIN 90214
 Tooth Lock WasherDIN 9852
 ScrewM10x302
 ScrewM6x202

Tools needed

Allen Key 5mm Allen Key 8mm Spanner 17

Instructions

  1. Place the 2 round brackets and add two M10 screws. Secure the whole by tightening the M10 lock nuts.
    1. Place the angle brackets on the back of the plate respecting its orientation.
      1. Place the washer and the tooth-lock washer on the holes.
        1. Insert the M6x20 screw through the whole and secure by tightening the M6 lock nut.
          1. Repeat steps 3-7.

            Animation

            Make sure that both brackets are aligned before tightening down.