1. Mounting The Spoilerboard

Step #01

List of Components

ItemSpecQty 
SML
 Sliding NutM6183030
 DIN912 ScrewM6x16183030
 MDF board200355

Tools needed

Allen Key 5mm

Animation

Instructions

  1. Insert the sliding nuts into the profile'slot. Leave 140mm between each nut.
    1. Place the MDF board over the table frame and make sure that the holes and the sliding nuts are aligned
      1. Make sure the board you install is aligned with the preivous one
        1. Tighten it with the screws
          Make sure the spoilerboard is 15mm away from the aluminium frame at the front as well
          We highly recommend to tighten the screws by hand. If you decide to use a screw gun, be very careful not to over-tight them, since it could deform the aluminium profiles of the machine frame.