9. Cable Management

Step #13 - Placing the Emergency Stop

List of Components

ItemSpecQty
 Emergency stop button-1
 DIN912 screwM4x122
 Sliding nutM42

Tools needed

Allen Key 3mm Screwdriver

Instructions

  1. Insert 2 sliding nuts at the front left of the machine, inside the bottom slot of the profile.
    1. Open the emergency stop button by unscrewing the 4 top screws.
      1. Position the bottom part of the casing (the black part) in front of the 2 sliding nuts, located at the front aluminium profile of the machine.
        1. Use the M4x12 screws to tighten the casing to the profile.
          1. Put back the top part of the casing and close it using the 4 screws.
            1. Guide the cable towards the left vertical trunking, so that it doesn't hang.
              When attaching the bottom part of the casing, make sure that the cable is orientated down.

              Animation