9. Cable Management

Step #09a - Pre-placing the Laser Cable (add-on)

Instructions for the laser head add-on. You can skip this step if you didn't purchase this product.

List of Components

ItemSpecQty (S/M/L)
 Laser Control Cable5m1

Tools needed

-

Instructions

  1. Open the laser add-on box and grab the 5m long cable.
    1. Place the cable inside the cable chain, next to the motor and sensor cables.
      1. Let the cable protrude about 30cm from the end of the cable chain.
        Follow the next steps as explained, not forgetting to route this laser cable with the Z-axis cables.