9. Cable Chain Management

Step #03 - Attaching the Y-axis Cable Tray Supports

List of Components

ItemSpecQty
 Cable tray support-2
 DIN912 screwM6x124
 Sliding nutM64
 DIN9021 WasherM64
 Cable tray1500mm1
 Cable tie-4

Tools needed

Allen Key 5mm

Instructions

  1. Insert 2 sliding nuts on the middle vertical profile and on the back vertical profile.
    1. Attach the 2 cable tray supports using 2 screws and 2 washers each time. They should be both facing up, 15cm away from the rack.
      1. Place the cable tray on the supports, slide it into the notches and attach it using 2 cable ties on each support.

        Animation

        To firmly attach the cable tray, use the cable ties as shown in the pictures below.