1. X-axis Carriage
Step #05 - Installing the Ballscrew
List of Components
| Item | | Spec | Qty |
|---|
| | X-axis motor plate | Steel 8mm | 1 |
| | Spacer | M5x30 | 4 |
| | DIN9021 Washer | M4 | 4 |
| | DIN912 screw | M4x55 | 4 |
| | Locknut | M4 | 4 |
Instructions
- Position the ballscrew assembly as shown in the animation, with the flat face of the nut housing facing upwards.
- One by one, place a spacer and a washer, and then insert a screw to tighten it with a locknut.
- Do not fully tighten the 4 screws, it will be done later.
Animation
