1. Table Frame

Step #17 - Attaching the Linear Rails on the Frame (2/2)

List of Components

ItemSpecQty
 DIN912 screwM6x1612
 Sliding nutM64
 DIN9021 washerM612

Tools needed

Allen Key 5mm

Instructions

  1. Using the screws from the previous step as a guide, slide the profile and linear rail assembly on top of the frame, with the rails facing outwards.
    1. Be extra careful to place the linear rails facing outwards, with their sharp edge touching each other, and mainly that the threads in the aluminum profiles still show themselves in the front and the back of the frame.
      1. Slide the pre-placed nuts in front of the angle brackets and use 1 screw and 1 washer to fasten each.
        1. Add 1 sliding nut to the bottom slot of each corner and fasten the 2 remaining angle brackets using 1 screw and 1 washer each time.
          1. Do not fully tighten the screws yet.
            1. Replicate the same assembly on the other side of the frame.

              Animation

              The profiles should join each other at the centre of the vertical profile.