2. Table assembly

Step #02 Mounting the Feet

List of Components

ItemSpecQty
 DIN912 ScrewM6x1216
 Sliding NutM616

Tools needed

Allen Key 5mm Frame Gauge

Instructions

  1. Insert 4 sliding nuts in the aluminium profile as shown.
    1. Repeat this process on the facing profile.
      1. Pre place the feet assembly and match the holes with the sliding nuts.
        1. Insert 4 screws but don't tighten them yet.
          1. Repeat this process on the facing profile.
            1. Use the frame gauge to properly align each foot. Then tighten.
              1. Repeat all these steps to obtain 2 assembled profiles.

                Animation

                Use the custom gauge to position the foot profiles on the frame correctly.