2.Assembling The Structure

Step #07b

This step is only necessary if you have a worktable SIZE L.

List of Components

ItemSpecQty (S/M/L)
 Sliding nutM66

Tools needed

Allen Key 5mm

Instructions

  1. Remove temporarily the four sliding nuts
    1. Install six sliding nuts into the crosswise profile (three in each slot)
      1. Slide the crosswise profile as shown
        1. Tighten the crosswise profile once it is exactly at the middle of the structure
          1. Place back the four sliding nuts you removed before

            Animation

            Make sure the crosswise profiles are aligned with the 6060 profiles.
            Make sure pre-inserted nuts of the crosswise profiles are correctly oriented