7. Spoilerboard

Step #06 - Face Milling the Spoilerboard (2/2)

List of Components

ItemSpecQty
 Face mill25mm1

Tools needed

Spanner 30mm Spanner 22mm

Instructions

    Re-Defining the Z reference

  1. Place the crocodile clip on the endmill shaft
  2. Place the probing device underneath the endmill on the MDF surface
  3. Press on the "Tool measure length" button
  4. Lastly, do not forget to install the dust shoe brushes

    Charging the G-Code

  1. Do not forget to turn on your dust collection system.
    1. Do not forget to turn on your vacuum table system
      1. Press the "PLAY" button play