6. Installing the Vacuum Pump

Step #05 Placing the Electrical Socket

List of Components

ItemSpecQty
 Electrical Socket-1
 Screw4x504
 Wall Plug-4
 Cable tie450x5mm2
This step must be carried out in compliance with safety standards. Reach out to a professional if you don't have the required skills.
Acting otherwise can lead to life-threatening hazards.
Connect the vacuum to a circuit with a 32 Amps breaker.

Instructions

  1. Locate and mark the drill holes.
    1. Unscrew the electrical socket.
      1. Connect the cables accordingly.
        1. Close the socket.
          1. Drill the holes and place the wall plugs.
            1. Attach the socket with the four screws.
              1. Connect the switch's cable to the electrical socket.
                1. Use the cable ties to tidy up the cables and fix them on the FAB frame.