Laser on Evo

Step #05 - Connecting the Laser Head

List of Components

ItemSpecQty
 Docking Station Cable5m1
 Laser Control Cable100mm1
 Cable Cover330mm1
 Cable Tie-5

Tools needed

-

Instructions

  1. If not done it yet, use the short 100mm cable to connect the input and outputs of the laser head.
    1. Connect the docking station to the long 5m cable.
      1. Insert the cable cover into the side slot on the left 3030 profile, open side up.
        1. Press the cable inside the cable cover (push hard to secure it firmly).
          1. Use a cable tie to attach all the cables together on the top of the Z-axis.
            If you already own an Evo, you will have to open the cable chains and guide the laser cable through them, all the way to the control unit.