Step #01 - Configuring PlanetCNC (1/2)

• Home
• Documentation
• High-Z Upgrade
• High-Z Pro/Fab
• Assembly Guide
• Configuration & Testing
• Step #01 - Configuring PlanetCNC (1/2)

Step #01 - Configuring PlanetCNC (1/2)

Instructions

1. Make sure that all the electronic components are reconnected (motor, sensor, spindle)
2. Turn on your control unit.
3. Go to the settings of PlanetCNC: File > Settings > Motors > Limits
4. Increase the "Z+ limit" value to 210mm.