2. EVO/PRO - Table Mount + ENC

Step #04 - Final assembly

List of Components

ItemSpecQty 
 ScrewM6x204
  Sliding NutM64
 WasherM64
 Tooth lock washerM64

Tools needed

Allen Key 5mm Allen Key 8mm

Instructions

  1. Insert the 4 sliding nuts in the railing.
    1. Position the connection plate and align it with the sliding nuts in the railing.
      1. Add the washer, tooth lock washer -pass the M6 screw through to fix the whole.
        1. Repeat steps for the four screws.
          1. Slide the lower tube into the brackets and tighten down hard.
            1. Slide the upper tube onto the bottom one.

              Animation

              Make sure the connection plate is screwed down tight.