7. Frame & Gantry Assembly

Step #03 - Connecting the Y-axis Ballscrews

List of Components

ItemSpecQty (S/M/L)
 Nut offset plate-2
 DIN912 screwM5x258

Tools needed

Allen Key 4mm

Instructions

  1. Remove the 2 wedges from under the gantry.
    1. Gently move the gantry towards the ballscrew nut. Make sure that the nut housing flat face is orientated against the steel part.
      1. Place the offset plate in between the nut housing and the steel part, and use 4 screws to tighten them together.
        1. Repeat this operation on the other side.

          Animation